Network service, which can be one of the following: The traffic destination, which can be one of the following: Localip : The set of all local IP addresses on the system, on which the ACL is applied. The traffic source, which can be one of the following:Īlias: The network resource (use the netdestination command to configure aliases use the show netdestination command to see configured aliases) The output of this command may include some or all of the following parameters: The example below shows general information for all ACLs in the Access List table. Specify the name of a single ACL to display detailed information on that ACL. The VLAN output parameters was introduced.Īvailable in Config or Enable mode on master or local controllersĭisplay a table of all configured access control lists (ACLs), or show details for a specific ACL.ĭisplay a table of information for all ACLs. Ĭonfigure an access group for an interface. Interface fastethernet | gigabitethernet ip access-group. Shows whether or not the session ACL is configured. If the ACL was applied to a VLAN associated with this port, this column will show the VLAN ID. Name of the ACL applied to the interface. The output of this command includes the following parameters:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |